Basic Installation Guide For a Lorenzetti Shower:

A Step-by-Step Guide

If you've recently purchased a Lorenzetti shower and are wondering how to install it, this comprehensive guide will walk you through the process. The Lorenzetti showers are known for their efficiency and convenience, and with a few simple steps, you can have your new shower up and running in no time.
Before you begin, make sure you have all the necessary tools and equipment handy. Here's what you'll need:

• Lorenzetti shower kit

• Adjustable wrench

• Pipe tape or Teflon tape

• Screwdriver

• Plumbers putty or silicone sealant

• Towels or rags

• Bucket or container to catch water

• Circuit breaker

• Cable

• Cable joining Kit

Now, let's dive into the installation process:

Step 1: Preparation

Before getting started, turn off the main water supply by shutting off the valve in your bathroom or your home's main valve. This will prevent any potential water leaks during installation.

Step 2: Removing the existing showerhead

Use an adjustable wrench to loosen and detach the existing showerhead from the shower arm. Wrap a rag or towel around the shower arm to protect the finish while using the wrench.

Step 3: Apply pipe tape

Take the pipe tape or Teflon tape and wrap it around the threaded end of the shower arm. This helps create a watertight seal and prevents any leaks.

Step 4: Installing the shower arm bracket

With the shower arm still in place, attach the shower arm bracket from the Lorenzetti shower kit onto the shower arm.

Use a screwdriver to tighten it securely.

Step 5: Installation of the showerhead

Attach the showerhead to the shower arm bracket. Twist it gently by hand to ensure a snug fit. Use an adjustable wrench to tighten it further if necessary, but be careful not to overtighten, as it may cause damage.

Step 6: Electrical Connection - Circuit Breaker and Cable Sizing

6.1: Circuit Breaker Installation

Ensure the circuit breaker for the shower unit is installed correctly. It should be rated according to the shower's power requirements, typically around 40-50 amps, but always check the specific requirements for your model.

6.2: Cable Sizing

Select the appropriate cable size for the electrical connection. For most Lorenzetti showers, a 6mm² (10 AWG) cable is recommended, but verify the exact specifications in your shower's manual. Run the cable from the circuit breaker to the shower's connection point, ensuring it is properly insulated and secure.

Step 7: Sealing the connections

To prevent any leaks, apply a small amount of plumbers putty or silicone sealant around the connection between the shower arm and the bracket. This will ensure a watertight seal.

Step 8: Testing and adjustments

Now that the installation is complete, turn on the main water supply valve. Make sure to check for any leaks around the showerhead and connections. If you notice any leaks, tighten the connections slightly or reapply sealant as needed.

Step 8: Final adjustments

Adjust the showerhead to your desired angle and height. Some Lorenzetti showers come with adjustable settings, allowing you to customize your showering experience. Take your time to find the optimal position for your comfort.
Congratulations! You have successfully installed your Lorenzetti shower. Enjoy the invigorating and refreshing experience it offers with every use.
Remember, if you encounter any difficulties during the installation process or if you're uncertain about any step, it's always best to consult a professional plumber for assistance.